Philodendron 69686 is one of the beautiful Philodendron species, which has a unique leaf shape that makes it very special. In its natural habitat, this plant cannot grow without the support of its tree.
Philodendron 69686 has thick and long roots, which it uses to absorb moisture and food nutrients. This plant has fleshy stems, which are woody at the base.
The size of the alternate, petiolate leaves sometimes reaches two meters in length. Leaf plates are oval, and in some cases, they may vary in size and shape.
As a rule, the leaves of a philodendron 69686 have a beautiful shiny and green color. This species does not need much space for normal growth and development. It is grown in a hanging planter or basket like a common ampelous plant.
Philodendron 69686 Care Tips
For the Philodendron 69686 to be lush and beautiful, you should choose the right place for it. This plant requires proper light exposure to carry out photosynthesis throughout its life.
If there is a lack of light, the leaves of Philodendron 69686 will lose color and will become droopy and dull. This is why you are required to place it in the well-lit spot in the house.
It must be understood that Philodendron 69686 is native to the tropics and is entirely not adapted to low temperatures, even a short stay in the cold will cause the death of the plant.
The optimum temperature in the room is from 12°C to 32°C. It is unacceptable to drop below 10o C in the summer in the heat. If you want to cool the leaf plate, it is advisable to spray the plants often.
From May to September, 2-3 times a month, fertilizing is carried out with a highly diluted organic composition. Use 30-50% of the usual dose. The Philodendron 69686 is fed 1-2 times a month with a mineral complex for the rest of the year.
Young plants in fertile soil are fed much less often. You can use organic fertilizer because it adds a balanced amount of nutrients to the soil and has no drawbacks. Eggshells, grass clippings, tree leaves, banana peels, and coffee beans are suitable organic fertilizers.
Philodendron 69686 needs to be watered regularly, especially during spring and summer. The plant is watered as the top layer of the earth dries up.
The watering frequency depends on the air temperature in the room where the plant is located. Excess water should not remain in the pan. It is poured out one hour after watering. In winter, water the plant very carefully. At low room temperatures, watering is reduced.
Due to excessive watering, the philodendron 69686 will hurt, and the leaves will turn yellow. It is also impossible to over dry the earthen lump.
Due to drought, this plant will lose its attractiveness and shed its leaves. Water the plant with soft water (rain, boiled, settled). Also, it should not contain lime impurities, so well water is not suitable for this purpose. Otherwise, streaks will remain on the leaves of the plant.
5. Air humidity
Under natural conditions, the philodendron 69686 grows in the tropics; therefore, it needs high humidity. The plant must be regularly sprayed, especially during the heating season.
If there is dry air in the room, the plant’s leaves will become small. Younger specimens will love the shower.
To increase moisture, you can moisten a stick with coconut fibers, which supports the philodendron 69686. Do not forget to wipe the plant’s leaves with a damp cloth.
For spraying, use soft and warm water. Such a hygienic procedure improves the appearance of the philodendron and increases the humidity.
By nature, philodendron 69686 is epiphytic species, and the roots actively absorb oxygen and cannot live in heavy soil. At home, the main requirement for the substrate is its porosity and air permeability.
For this plant, a mixture consisting of about 50% of the orchid substrate with the addition of high peat, sand or perlite, leaf or grass humus is suitable. Such a composition provides unhindered access to oxygen to the roots, quickly passes water through itself, remaining moist for a long time.
7. Top dressing
Philodendron 69686 prefers animal excrement, insect waste products, rotted tree foliage, and rainwater in its natural habitat. Unfortunately, in room conditions, this cannot be provided to it.
During the period of intensive growth, the philodendron will not refuse feeding. Fertilizers provide it with a range of nutrients. It is brought in from March to September. In other months, you can also feed it but less often.
Once a month is sufficient if the plant is in a warm room. For top dressing, you can use complex mineral fertilizers. Fertilizers are also suitable for decorative deciduous plants.
To make the philodendron 69686 stretches in height, fertilizers with a high nitrogen content are used. If the plant needs to be compact, it is limited to nitrogen fertilization.
Transplant the philodendron 69686 in the same way as other plants. Young specimens should be replanted every year, adults – as needed, approximately every 2-3 years.
A cramped pot serves as a signal for transplanting. Each time it should be a little more spacious than the previous one. Because of the cramped pot, the philodendron 69686 will wither. Quite mature plants can be hauled over and replaced with topsoil.
This plant prefers nutritious, light, porous, slightly acidic, and breathable soil. To grow it, you can use an earthen substrate for orchids, including charcoal, sphagnum moss, peat, and bark.
A soil mixture consisting of sod land, peatland, and humus, half part of sand is suitable. Older plants are grown in different soil, prepared from equal parts of coniferous, leafy soil, sand and peat.
Reproduction of Philodendron 69686
New Philodendron 69686 can be obtained in several ways. It reproduces by apical cuttings, which gives the best results. Even novice florists can use this method.
The optimum temperature for breeding is 25-30 degrees. The process will accelerate in high humidity. To provide it, use a plastic bag or glass cover.
Planted cuttings are thoroughly ventilated. First every other day, and then more often. It is also necessary to remove condensate that accumulates on the greenhouse walls.
Wet sand is best for rooting. It is necessary to rejuvenate the Philodendron 69686 so that its branches are lush and beautiful.
Future plants should be ventilated every two days, and the water should be changed once a week. Rooting usually lasts 2 to 4 weeks, after which the cuttings can be replanted to a permanent location.
Reproduction by heel cuttings
Philodendron 69686 is bred with heel cuttings – meaning a leaf cut with cuttings and a piece of old bark.
The planting material is rooted in a peat-sand mixture, and once the roots appear, they are transferred to a pot with a suitable substrate. A reproduction method such as layering is quite effective.
To do this, a shallow incision is made on the side shoot, a stick or match is inserted, wrapped in wet moss, and fixed with a film. Philodendron 69686 needs to be moistened periodically.
As a result, roots appear in a couple of weeks. The shoot is separated from the parent and transplanted into a permanent container. The roots will appear in 2-3 weeks.
Pests and diseases
If the rules for caring for the plant are not followed, problems may develop.
- The tips of the leaves dry up. This is a consequence of the lack of moisture in the air, soil, and drafts. To reanimate the plant, you should increase the frequency of spraying and rearrange the plant in a place protected from cold air masses and normalize the irrigation regime.
- If the edges of the leaf plates begin to brown and the young leaves become smaller, there is an excess of moisture. It is best to transplant Philodendron 69686 and temporarily limit watering in this situation.
- With a lack of light, the leaves fade and lose their decorative effect. This requires artificial lighting or moving a pot with a vine to a more illuminated place.
- Leaf curling is the result of an overabundance of fertilizers. In this situation, transplanting and temporary cessation of feeding help.
- But the desire and dropping of the lower leaves is a natural process. In this situation, you do not need to do anything.
Philodendron 69686 is a unique plant where the color of the upper leaves of the flower is of a darker shade than the lower ones.
The color of the leaves is shiny and green, with the upper side being more intensely colored than the lower. The rich and varied foliage allows you to create extraordinary compositions using only philodendron 69686.
It can be grown in a single bush, and the other in the form of a vine, which will braid the support prepared for it, creating an arch or hedge. This plant can be used for vertical landscaping by providing a damp vertical wall.